M0275-01
Model 3700
5-10
Rev. 10/18
TM
Lubrication and Maintenance
MOUNTING BOLTS AND HARDWARE
Before operating planter for the first time, check all hardware is tight. Check all hardware again after first 50 hours of
operation and beginning of each planting season.
All hardware used on the Kinze planter is Grade 5 (high strength) unless otherwise noted. Grade 5 cap screws are
marked with three radial lines on the head. Hardware must be replaced with equal size, strength, and thread type.
Loose transport wheel lug nuts can
result in wheel separation from planter
and can result in death, serious injury,
and damage to property and equipment.
Check transport wheel lug nut torque
before operating planter for the first time
and periodically thereafter.
WARNING
Over-tightening hardware can reduce
its shock load capacity and cause
equipment failure.
NOTICE
TORQUE VALUES CHART - PLATED HARDWARE
Grade 2 (No marks)
Grade 5 (3 marks)
Grade 8 (6 marks)
Diameter
Coarse
Fine
Coarse
Fine
Coarse
Fine
¼
"
5.6 Nm
6.3 Nm
8.6 Nm
9.8 Nm
12 Nm
14 Nm
5∕16
"
11 Nm
12 Nm
18 Nm
19 Nm
24 Nm
27 Nm
⅜
"
20 Nm
23 Nm
31 Nm
35 Nm
45 Nm
50 Nm
7∕16
"
34 Nm
37 Nm
50 Nm
56 Nm
71 Nm
79 Nm
½
"
48 Nm
54 Nm
77 Nm
87 Nm
108 Nm
122 Nm
9∕16
"
68 Nm
81 Nm
108 Nm
122 Nm
156 Nm
176 Nm
⅝
"
95 Nm
108 Nm
149 Nm
169 Nm
217 Nm
244 Nm
¾
"
176 Nm
197 Nm
271 Nm
298 Nm
380 Nm
427 Nm
⅞
"
169 Nm
190 Nm
434 Nm
475 Nm
610 Nm
678 Nm
1"
258 Nm
278 Nm
651 Nm
719 Nm
915 Nm
1017 Nm
1
⅛
"
359 Nm
407 Nm
814 Nm
908 Nm
1302 Nm
1458 Nm
1
¼
"
508 Nm
563 Nm
1139 Nm
1261 Nm
1844 Nm
2034 Nm
1
⅜
"
664 Nm
759 Nm
1491 Nm
1695 Nm
2413 Nm
2752 Nm
1
½
"
881 Nm
990 Nm
1966 Nm
2237 Nm
3128 Nm
3620 Nm
Summary of Contents for 3700
