M0275-01
Model 3700
2-26
Rev. 10/18
TM
Machine Operation
FIELD TO TRANSPORT SEQUENCE
Position planter in a relatively flat open area without furrows, etc.
SUMMARIZED FIELD TO TRANSPORT SEQUENCE
1. Install marker lockups.
2. Raise planter to fully extend master/slave cylinders.
3. Install center (slave) lift cylinder lockups.
4. Lower planter onto center lift cylinder lockups.
Folding planter without using tractor to
assist may cause equipment damage
especially in soft conditions or when
loaded with seed or fertilizer. Use tractor
to reduce stress on frame, drive, and
transport components.
NOTICE
5. Place tractor in low forward gear and hold in clutch. Start folding planter and
move tractor slowly forward as planter folds to keep wing wheel side pressure to
a minimum.
6. Raise hitch parallel linkage to engage wing hooks.
7. Install hitch parallel linkage lock pin or lockup bracket.
8. Lower hitch parallel linkage cylinder.
NOTE: Read following information for detailed instructions.
Planter hitch may raise uncontrollably
during folding/unfolding and can cause
death, serious injury, or damage property
and equipment. DO NOT fold or unfold
planter without planter attached to a
tractor. DO NOT unhitch planter from
tractor unless fully folded for transport
or fully unfolded with planting units
lowered to ground.
WARNING
Summary of Contents for 3700
