7
-2
Ds4110(hs) / Ds4510(hs)
2
5
10
3
7
4
9
8
6
1
2
5
10
3
7
4
9
8
6
1
T46W233A
(1) Fuel Tank
(2) Fuel Filter
(3) Fuel injection pump
(4) injection pipe
(5) injection nozzle
(6) Fuel Overflow Pipe (Hose)
(7) Fuel Feed pump
(8) Bleeding Bolt
(9) Bleeding hose
(10) nozzle holder nut
2. If there is air in the fuel filter, turn the filter cock to the air side and turn
the ignition key to turn the start motor. Then, the air in the filter port is dis
-
charged through the bleeding hose as shown in the figure.
3. When the amount of the fuel in the fuel filter port goes over 3/4 level, stop
cranking the engine and turn the cock in the figure to the “ON” (open) posi
-
tion.
4. unscrew the bleeding bolt in the
figure and crank the engine to
bleed the system. Then, tighten
the bolt.
5. if the engine still cannot be started
even after performing the above
step, unscrew the 1 or 2 nozzle
holder nuts out of 3 or 4 and crank
the engine to bleed the system.
6. when air bubbles aren`t seen any-
more in the drained fuel, tighten
the loose parts and start the en-
gine.
it is not necessary to bleed the
system if filling the pot with fuel
before installing the fuel filter.
Do not operate the start motor
for more than 10 seconds con
-
tinuously. Instead, operate it
for several times within 10 sec
-
onds each time.
CAUTION
NOTE
M50-EU-07.indd 32
2009-09-28 오후 6:11:49
Summary of Contents for DS4110
