7
-12
Mec 2230sW
(1) Drain plug
4. place a container under the drain
plug and remove the drain plug to
drain the oil to the container. be
careful as the engine oil may be
hot.
ChANGING ENGINE oIl AND fIlTER (f)
1. Warm up the engine oil by operat-
ing the engine for approx. 10 min-
utes or driving the vehicle.
2. park the vehicle on level ground,
stop the engine and apply the
parking brake firmly.
3. remove the inspection shield and
seat cushion.
UUVo709A
(1) oil filter
5. remove the oil filter through the
inspection shield and discard it.
6. Apply a thin film of oil to the rub
-
ber O-ring of a new oil filter. Then,
install it by tightening it firmly to its
end by hand.
7. Install the drain plug firmly.
UUVo710A
(1) filler cap
8. Open the filler cap and slowly add
new oil.
9. the engine oil capacity for this ve-
hicle is as follow.
10. Install the filler cap.
11. start the engine and run it at a
low speed without load. then,
check if any oil has leaked.
UUVo711A
oil Capacity
3.2 l (0.85 u.s.gal.)
UD130(MEC2230SW)-유럽향-07.indd 12
2015-10-28 오후 12:01:47
Summary of Contents for MEC 2230SW
Page 112: ...MEMO MEMO UD130 MEC2230SW 05 indd 28 2015 10 28 4 46 44...
Page 116: ...MEMO MEMO UD130 MEC2230SW 06 indd 4 2013 12 18 7 16 00...
Page 165: ...TROUBLESHOOTING vehicle Troubleshooting 9 2 9 9 UD130 MEC2230SW 09 indd 1 2013 12 18 7 25 06...
Page 173: ...10 INDEX index 10 2 10 UD130 MEC2230SW 10 indd 1 2015 10 28 11 54 16...
