3 Operation of components
▆
Switch of head lamp
If driver holds the switch of head lamp, head lamp,
clearance position lamp and panel turn on.
High/low Danger Head lamp Stop brake
speed shift button button
▆
Switch of stop brake
Indicator of stop brake lights after it is pressed
down to activate the stop brake. Then loader
cannot run even if operating lever of forward and
backward is operated. Re-press it and indicator
turns off to release the stop brake.
▆
Switch of high/ low speed shift
It is used to make a switchover between high and
low speed.
■
Alert switch
Turn on the alert switch when loader runs or stops
on the road in order to avoid impacting person.
Indicator of turning blinks if alert switch is held.
Re-press the alert switch and indicator of turning
turns off.
▆
Throttle pedal
Operate the pedal to adjust the speed of loader
and bucket in accordance with change in rotation
of engine. Press down the pedal to increase the
speed.
Additional information
z
Start rpm of engine changes with conditions of
ground. It is 1000-1200rpm normally if loader
starts on the flat ground. Press down the
pedal slowly to start the loader.
Throttle pedal
Pedal of stable Brake pedal
movement
■
Brake pedal and pedal of stable movement
Hold the pedal to control the loader. As left and
right pedals are linked, either of them can
perform same control. Press down the pedal
slightly and hydraulic system is in neutral.
Special hydraulic brake is triggered and loader
decelerates.
▆
Fuel tank cover On/off
1. Insert the start key and turn it left to uncover
the hood. Then turn the cover left and open it.
2. Turn the cover right and close it. And turn
the start key right to close the hood.
Cover of oil intake
■
Operating lever of bucket
Operating lever of bucket can complete all
actions of bucket and moving arm.
1 Lift the moving arm N At neutral
2 Descend the moving arm
3 Float
（
above the ground
）
A Turn over the bucket
B Raise the bucket
3
2
B N A
1
Operating lever
of bucket
14
Summary of Contents for KDD03
Page 2: ......
