5 Maintenance
▆
Check and filling of cooling water
Spare tank is available on radiator for automatic
filling of cooling water in case of insufficiency.
Check cooling water level often and fill in
immediately if insufficient.
At this moment, remove lid without taking down
pipe. Pay attention to installation direction of lid. It
means normal if the cooling water level is
between upper and lower limits. If a plenty of
water is needed, check for any leakage and take
proper measures.
Spare tank Radiator lid
Important
* Cooling water level can never exceed max. limit
of spare tank.
* Slurry or sea water is strictly forbidden.
Please use tap water (soft water) as possible.
* Do not open radiator cover immediately after
shut down of the machine. Because the hot water
sprayed out may cause personal hurt.
* Do not open radiator lid in ordinary work.
* Check cooling water with spare tank during
engine cooling.
Supplementary
* Long-term storage coolant has been added into
cooling water before delivery (mixing proportion:
antifreeze: 50%; cooling water: 506).
▆
Check and fill of engine oil
1. Check engine oil level to see if it reaches
regulated level.
2. Check oil level with oil gauge. It means normal
if it’s between upper and lower limits.
3. In case of insufficiency, fill in immediately.
Oil gauge Engine oil filling opening
Important
* Select engine oil with suitable viscosity as per
air temperature.
Supplementary
* Do not measure engine oil level immediately
after shut down of engine due to residual oil on
each part.
Adjust the machine to horizontal direction and
carry out inspection at least 5 minutes after shut
down of engine.
■
Clean and inspection of vehicle embedding
in soil or marsh
1. Flush directly and remove earth on vehicle if it
runs into marsh or soil,
2. After flushing and cleaning, check the following
parts:
◎
Grease filling device on universal joint; 3
points.
Grease filling
25
Summary of Contents for KDD03
Page 2: ......
