27
KPD100 control panel
Fig.3-21 KPD100 control panel
1. Key functions
Stop/param
eter
-
key
Press the key
to stop the running generator at running state and
reset the alarm at alarming state.
Press this key to choose
-
for parameters when at “Parameter set”
mode.
Manual
startup/para
meter+ key
Press the key
to start the still generator under manual mode.
Press this key to for parameters when at “Parameter set”
mode.
Auto/param
eter
increase
key
Press the key
to set the generator to be under “AUTO mode”.
Press this key to increase parameters when at “Parameter set” mode,
equal to “+”
Manual/par
ameter
saving key
The key
is to set the generator to be under “MAN mode”.
Press it to switch the load between power when at manual mode.
Press it under parameter configuration mode can save the parameter
value. It equals to “ok”.
The operating mode is automatically turned into “MAN mode
” after KPD100 controller
initialized.
KPD100 controller has the function of protection.
When fault occurs:
· System outputs alarm signals, the corresponding LED indicator turns on or winks.
The relative data of KPD100controller and ATS switching data:
2. Engine
Summary of Contents for KPEC Series
