4.4.
Installation procedure
First the CVF4 is screwed flat on its mounting plate. In case the CVF4 is mounted on a solar tracker, the
tracker has to be levelled first.
On our sun trackers the CVF4 is positioned such that the fan sticks out over the edge of the plate. This
ensures the air inlet is never blocked (see picture of the CVF4 on the SOLYS2 Sun Tracker on the next page).
The locations of the CVF4 mounting holes on the SOLYS2 top mounting plate are shown below.
CVF4 mounting holes
When using your own mounting plate, make sure the CVF4 is mounted in the same way with the fan sticking
out. The CVF4 mounting holes size and distances are indicated in the drawing below.
The CVF4 is mounted with the supplied 4 washers and 2 screws through mounting plates from 4 to 8 mm
thick. The other 2 feet are for stability but do not need screws.
Summary of Contents for CVF4
Page 1: ...Instruction Manual CVF4 Ventilation Unit V2007 01...
Page 17: ...17...
