DE
EN
FR ES
37
!
V-notch as mark
spindle nut
10
union nut
www.kipp.com
export@kipp.com
Tel. +49 7454 793-0
–
Do not exceed the permissible tractive force of 60 kN (at 140 Nm).
–
The maximum clamping travel of 1 mm per jaw must not be exceeded at the downthrust clamping.
–
Check that everything is correctly and securely mounted before any milling work.
–
Check that all the screw connections are completely tightened to the correct torque.
–
The clamped workpiece may only have a maximum parallel displacement of 0.5 mm along the entire clamping width.
–
K0946 pin with Ø 6 mm cup point; universal pin for positive clamping without pre-embossing
(e.g. machining blanks).
–
The spindle nut may not be moved beyond the marking (V-notch) on the shaft. This ensures that a sufficient number of
threads is always used.
–
The union nut must contact the face of the extension shaft before assembly.
-
To prevent damage to the thread, the distance between the union nut and the extension / adapter shaft when mounted
must not exceed 10 mm.
2 . S A F E T Y A N D W A R N I N G N O T E S
Attention: The following points must be observed!
