11
© 2015 KIRAMEK, INC.
11
PROGRAMMABLE FEATURES
You can change some features of the 1460 by using the Program
Switch. Perform the following
4-step procedure
to change the fea-
tures shown in
Table-2
:
1.
Start the engine and then Stop the engine.
(Only required for Hybrid cars.)
2.
With the Ignition OFF, Arm the 1460 and then immediately Disarm.
3.
Within 20s, turn ON the Ignition.
4.
Press the Program Switch the same number of times as the feature you
want to program — refer to the “No.” column in
Table-2
below.
(For
example, to change “Auto Arm,” pus
h the Program Switch 8 times.)
5.
Turn OFF the Ignition.
TABLE-2
Feature Selection Menu
No.
Feature Description
Toggle Settings
3
Ignition Trigger
IG Protect
RSCM
4
Safety Lights During Remote Start
OFF
ON
7
Safety Lights: Flashing or Solid-ON
Solid-ON
Flashing
8
Auto Arm
OFF
ON
9
Siren Output
Continuous
Pulsed
10
Auto Rearm
OFF
ON
17
Exterior Illumination
OFF
ON
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
1)
After you complete Step-5 above, the Status LED will flash the same
number of times as the feature you just programmed. Because the set
-
tings merely “toggle,” there will not be any indication of the “Toggle
Setting” you just programmed. Test your 1460 system to confirm your
programmed settings. To program another setting, repeat the steps.
2)
To Reset to Factory Defaults, see method on page 13.
NOTES
