31
31
TRANSMIT TER LEARNING
You can program additional remotes to your 1014 system, or program a
remote to replace one that you have lost. You can program a total of 3
transmitters to the 1014.
Purpose
The following procedure will allow you to program transmitters:
Perform Steps 1 & 2 as described on page 25, turning the Ignition on-
1.
and-off 20 times. The Status LED will then flash 20 times.
After the Status LED flashes 20 times, you have 10 seconds to press and
2.
release Button-1 on the first transmitter you wish to program. The si
-
ren will then chirp once and the vehicle lights will flash once to confirm
your transmitter is learned. You will then have 10 seconds to press and
release Button-1 on the
next
transmitter you wish to program. (You can
program up to 3 total.)
Turn the Ignition on-and-off. The Status LED will flash the same num
-
3.
ber of times as the Force Reset Code, and the siren will chirp 3 times and
the lights will flash 3 times.
Transmitter learning is now complete!
Programming Transmitters
NOTE:
Initiating Transmitter Learning deletes all transmitters from
memory for security. You must therefore relearn all your existing re-
motes each time you want to learn new remotes.
NOTE:
You must have the GRN/WHT Ignition Input wire connected
to learn perform the transmitter learning steps on this page! See pages
7 and 9 for wiring details.
OPERATION
Summary of Contents for Vision 1014C
