11
© 2011-2020 KIRAMEK, INC.
11
PROGRAMMABLE FEATURES
The following
5-step procedure
allows you to change the features
shown in
Table-2
below:
1.
Start the engine and then Stop the engine.
2.
With the Ignition OFF, Arm the 1480 and immediately Disarm, then
perform the Steps 3~5 within 20 seconds.
3.
Turn ON the Ignition.
(LED will flash if a door is open.)
4.
Press the Program Switch the same number of times as the feature you
want to program — refer to the “No.” column in
Table-2
below.
(For
example, to toggle “Ignition Trigger,” push the Program Switch 3 times.)
5.
Turn OFF the Ignition.
(The LED will flash the same number of times as
the feature you just toggled. There is no “Toggle Setting indication,” so test
to confirm your programming.)
1)
To program another feature, repeat the 5 steps above.
2)
To
RESET
everything to factory defaults, perform the
CAN Signal
Learning
procedure on page 14 of the Installation Guide. But be sure
to read the “NOTE” there first.
NOTES
TABLE-2
Feature Selection Menu
No.
Feature Description
Toggle Settings
2
Require 2 Unlocks to Disarm (Toyota & Lexus)
OFF
ON
3
Ignition Trigger
IG Protect
RSCM
4
Hazard Flash During Remote Start
OFF
ON
5
Error Chirp
ON
OFF
6
Ignore Factory Unlock (Disarm) Signal
NO
YES
7
Door Ajar Hazard Flash
OFF
ON
8
Auto Arm
OFF
ON
9
Siren Output
Continuous
Pulsed
10
Auto Rearm
OFF
ON
11
GWA Output
(Pulsed required for Dash Cams)
Continuous
Pulsed
15
Speed Controlled Door Locking
OFF
ON
17
Exterior Illumination
OFF
ON
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
