© Kirami Oy, Finland
4 / 9
INSTRUCTIONS FOR USE: Original Chill ™ hot tubs
Fastening the heater
1.
Attach the upper rubber tube to the stove and
tighten the stove-side hose clamp securely.
2.
Attach the lower rubber tube to the stove, but do not
tighten it yet and leave the rubber tube closer to the
edge.
3.
Push the lower tube onto the tub first.
4.
Then attach the upper tube.
5.
When you are done, tighten all hose clamps securely.
Heater for plastic tubs is connected with rubber hoses to the
Ø75mm PVC pipes on the tub. In this installation the heater is
placed on the same level with the tub so both are directly in
contact with ground. And the heater is not hanging in the air.
On some plastic tubs this means that you have to add some
support (about 20mm)
under the heater e.g.
concrete slabs or
bricks. In the left
picture plastic tub
connection pipes. On
the right side you see
an example of heater
connected with plastic tub.
It is advisable to spray silicon spray or other lubricant like soap inside the rubber hoses to tighten
the hose clamps evenly and to prevent the hoses from wrinkling.
Chimney
Be careful, the edges of the chimney are very sharp. Use protective
gloves! The chimney is delivered in a separate box and it consists of four
parts (picture on right) and it needs to be assembled. Remove the
protective film from the thermal protection and place the assembled
chimney to the chimney outlet of the stove.
The first use
The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
USE
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface at
the minimum.
