VI-MMXII
Page 24
6.0
DRIVELINES AND POWER TAKEOFFS
6.1
Tractor PTO driveline
(I)
Shields must be secured by locking devices
(II)
Shields must slide freely.
(III)
Observe shields for damage.
(IV)
Driveline shafts must slide freely, binding may cause false readings on the scale
system. Lubricate all shaft splines.
(V)
U-joints cross & yoke must fit tight in the bearing cups and have zerk fittings for
lubrication.
6.2
Truck mounted mixer PTO’s
(I)
Observe for oil leaking around PTO shaft seal. Replace seal.
(II)
Check PTO for loose bolts holding PTO to transmission or engine crank shaft. Tighten
bolts.
(III)
Check U-joints, bearings, yokes, and set bolts. Replace worn parts and tighten all
bolts.
(IV)
Lubricate driveline “U” joints as per the “
Preventive Maintenance and Lubrication
Schedule”
6.3
Mixer drive line.
(I)
Check for loose or missing set screws or lock collars in pillow block bearings and
driveline yokes. Tighten or replace lock collars set screws.
(II)
Check for loose or missing bolts in pillow block bearings. Tighten or replace.
(III)
Observe driveline under operation. CAUTION STAY CLEAR OF ALL MOVING
PARTS, DO NOT WEAR LOOSE CLOTHING!!
(IV)
Check for vibration, worn bearings, bad U-joint bearings, or bent shaft. Replace worn
or damaged parts.
(V)
Observe for linear movement through bearings, this is indicated by unpainted surface of
shaft exposed on each side of bearing locking collar. Realign and tighten loose locking
bolts.
(VI)
Observe for loose set screws or PTO shaft not slipping in sleeve, causing end thrust load
on the bearings.
(VII)
Check for bent shaft. Replace and grease as per lubrication schedule.
Summary of Contents for LP1000
