A on LCD stands for the scanning channel, A will not show
for excluded channel.
Standby channel
To quit scanning and go back to standby channel, only hold
down PTT button while Scanning.
While transmitting, you must release PTT button, and then
press PTT button Again.
DTMF CALLING
MANUAL DIALING
There are two ways of manual dialling, and can the second
way take effect only your dealer have programmed it.
1) Holding down the PTT button, and enter the number with
keypad.
If your dealer have programmed, you do not need to hold
down PTT button without release.
The microphone is muted and the corresponding DTMF
tones are transmitted. You can monitor the transmitting Tone
by the sound from speaker.
2) Using the keypad, enter the desired digits (16 digits
maximum).
As each digit is entered, the digit is displayed and the
corresponding DTMF tone is heard. Press [DIAL] while the
Storing DTMF Numbers
One DTMF number with a maximum of 16 digits can be stored
in each of the 9 Auto-dial memory channels.
1. Press [DIAL] to enter Dial mode.
LCD display --------d
2.Press # Key to enter Storing mode.
3.Using the keypad, enter up to 16 digits maximum for the
number.
that you want to store. If incorrect digits are entered, press
[MONI] andre-enter the entire number.
4.Press [DIAL], and then [0]~[9], only press a single number
Corresponding to the desired Auto-dial memory channel,
the original display is restored.
Each time this key combination is pressed, the lockout
status.
Toggles ON And OFF for the selected channel.
digits are currently displayed.
The digits for the stored number scroll across the display
and Their associated DTMF tones are transmitted.
If so programmed by your dealer, no DTMF tone is
transmitted if D is stored since D represents a pause time.
However, the transceiver remains in the transmit mode for the
length of the pause time which is also programmed by your
dealer.
2
13
2
14
