INSTALLING THE BELT HOOK
If necessary, attach the belt
hook using the two 3mm
4mm
screws from the supplied screw
set.
INSTALLING WRIST LOOP
Holding the provided wrist loop,
put it through the ring on the
right side of the transceiver,and
then make a knot, refer to the
picture.
INSTALLING THE SPEAKER
/LOOP OF MIC
Use the optional KMC-17 or
KMC-21 speaker/MIC with the
supplied connecting loop.
1. Switch power off and remove
the panel from cap of MIC-SP.
2. Insert the speaker-microphone
plugs into the SP/MIC jack.
3. Circle the LOOP to the
position 4-5cm from plug, and
insert the plug into the loop and
fasten the loop.
4. Cut off the bottom of loop, and
insert the pin into the loop of the
right side of transceiver.
If the loop is removed and used
again later, make sure 1 or 2 cm
length separated from body.
To remove the connecting loop,
insert clip or iron wire into the
locking Position, and pull out the
bottom from the loop.
2
5
2
6
