Note:
Although using channels set with CTCSS/DCS tones relieves
you from listening to unwanted calls, it does not mean your
calls will be private.
Wired Clone
Connect two transceivers with specified copying cable, press
monitor and function button in the meantime to switch on, and
enter into the
user mode
, hold the Monitor key on the
sending transceiver and turn on the power at the same time,
the data will be copied from transmitting transceiver to
receiving transceiver. For transmitting transceiver, the LED
light will blink red during the data transmitting and will turn
green if the date transmitting is finished. The LED light will
blink green if receiving transceiver receives the data and the
green light will disappear if the data transmitting is finished. If
the data transmitting fails, the LED light of transmitting
transceiver will light red. To restart data cloning, both
transceivers need to be turned off and do the above
procedures again.
6. Specification
Specification
Frequency
RF power
Channels
Power Source
Dimension
Weight
High: 4W/ Low: 1W
(1)400~420MHz (2)450~470MHz
15+1
DC 6.0V or DC 7.2V
117mm x 56mm x 39mm
225 g with battery and antenna
7. Troubleshooting Guide
1
NO
2
3
4
Problem
Solution
Unable to talk
w i t h o t h e r s i n
the same group
Standby time is
s h o r t a f t e r
charging
Can not switch on
H e a r o t h e r
voices (not from
the same group)
in the channel
The battery power is low, and please
charge or change it.
The battery is not well connected, and
just remove the battery and reload it.
Battery life is ending, and please
change a new one.
It is out of communication range.
Please change the frequency and or
CTCSS tone and make sure to
c h a n g e t h e t o n e o n a l l t h e
transceivers in your group.
PT 3300
CTCSS/DCS
39 groups of optional standard CTCSS and 83 groups DCS are
available (PC programmable). Some channels may have pre-
programmed with CTCSS/DCS tones. A CTCSS/DCS tone is a
sub-audio tone which allows you to ignore (not hear) calls from
other parties who are using the same channel.
When you receive a signal that has a tone different from the
one set up in your transceiver, you will not hear the signal.
Likewise, signal that you transmit will only be heard by parties
whose CTCSS/DCS tones match the tone set in your
transceiver.
