Wired Clone Mode
If the wired clone function is enabled by PC software, after entering
the Wired Clone Mode, the radio needs to be restart to return to user
mode.
The operating steps go as follows:
1. Press and hold side button 2 while turning the radio power on to
enter Clone Mode. If the wired clone function is disabled, the radio
will enter User Mode.
2. Connect the slave radio with the master radio by a clone cable.
Then switch on the slave radio.
3. Press side button 1 of the master radio, the cloning starts. During
the data transmission process, the Led indicator of master radio will
light red, and that of the slave radio will light green. When the
cloning is finished, the red LED of the master radio will be off, and
the slave radio will restart automatically.
4. You can continue to clone data according to step 3.
Note:
The wired clone function can be enabled or disabled by the PC
programming software. Once the wired clone function is disabled,
the radio cannot enter Wired Clone Mode.
Troubleshooting
The radio
cannot be
switched on or
no display
after being
switched on.
Phase lock
loop unlocked
(Beeping)
Cannot
transmit
A. The battery and the radio are not reliably
connected. Please reinstall the battery.
B. The fuse of the power supply is burnt out.
Please change it.
C. The power switch is in failure. Please change it.
D. The battery is out of power, please recharge it
or change it.
E. The CPU is broken, please change it.
A. The channel frequency setting is out of range,
please reset the channel data.
B. The crystal oscillator of phase lock loop is
broken, please change it.
C. The oscillating tube is broken, please change it.
D. The phase lock loop IC is broken, please
change it.
A. The frequencies of both users are not the
same. Please select the same frequency channel
again.
B. The QT/DQT signals of both users are not the
same. Please reset it.
C. The radio is out of effective communication
range.
1
2
3
17
16
No
.
Problem Causes and Solutions
