9
8
Receive a Call
Release the PTT button to receive a call.
Your dealer can set QT/DQT signaling on your radio channels
by PC software. If you select a channel that has been preset
with the signaling, you will not hear other calls except those
from your own system.
Functions of Programmable Buttons
The dealer can assign one of the following auxiliary functions to
the top button, side button 1 or side button 2.
Description
No function is assigned.
Press the preprogrammed “Voice Annunciation”
button to change the language and mode of voice
annunciation, meanwhile, the current channel
number can be heard.
When the preprogrammed “Talkaround” button is
pressed, the next transmission will be at the same
frequency as at which it is received.
Press the preprogrammed “Lone Worker” button to
start/stop lone working.
Press the preprogrammed “Emergency Alarm”
button to make an alarm tone according to the
setting of the programming software or send your ID
or background sound to your partner or the system.
Function
None
Voice
Annunciation
Talkaround
Lone Worker
Emergency
Alarm
Emergency
Alarm Off
Scan
Nuisance Delete
(temporary)
High/Low Power
Switch
Momentary
Monitor
Monitor
Momentary
Squelch Off
Squelch Off
L o n e W o r k e r
Reset
Press the preprogrammed “Emergency Alarm
Off” button to quit the Emergency Alarm Mode.
Press the preprogrammed “Scan” button to
start/stop scanning.
If the radio stays at a noise channel while
scanning, press the preprogrammed “Nuisance
Delete” button to delete the noise channel
temporarily.
Press the preprogrammed “High/Low Power
Switch” button to switch between high and low
transmitting power of the radio.
Press and hold the preprogrammed “Momentary
Monitor” button to disable QT
、
DQT signaling,
and release the button to resume normal
operation.
Press the preprogrammed “Monitor” button to
disable QT
、
DQT signaling, and you can
receive signals that cannot be heard under
normal operation. Press it again to resume
normal operation.
Press and hold the preprogrammed “Momentary
Squelch Off ” button to open squelch; release it
to resume normal operation.
Press the preprogrammed “Squelch Off ” button
to open squelch. Press it again to resume
operation.
Press the preprogrammed “Lone Worker Reset”
button while the radio is in Lone Worker Mode
to reset the lone worker timer, and the timer
starts again.
No.
0
1
2
3
4
5
6
7
8
9
10
11
12
13
