o
The positive connection must be fused. (Do not use fuse
holders for porcelain fuses as these could give excessive
voltage drops and heat generation that could cause
malfunctioning and fire).
o
Use a 40 Ampere fuse in 12 Volt systems and a 30 Ampere
fuse in 24 Volt systems.
User guide
Before first use:
Clean the coffee machine with water before the first use.
Brewing:
•
Add the required amount of water into the clear water reservoir.
•
Place the steel container in the hole of the base and insert the filter
holder into the container with the opening and serving tip aligned.
•
Place a filter into the holder and add ground coffee. (The 6 cups uses
filter type 102 and the 12 cups uses type 1X4)
•
Close the lid and turn on the machine by pressing the start button shortly.
A short beep will confirm the start and the indicator light will become red.
•
The brewing time will be 1½ to 2 minutes per cup of coffee at 24 Volt and
2½ to 3 minutes at 12 Volt.
•
When finished the remaining water in the heater will vaporize. For a short
time this generates noise and steam.
•
The coffee machine will indicate the finished brewing cycle by a longer
beep and a green indicator light.
Important!
•
Leave the machine turned off for some minutes before pouring new water
into the water reservoir.
•
Use clean and fresh water only.
•
Do not fill the water reservoir above the maximum capacity of the coffee
machine.
•
Newer lift the lid during the brewing process.
•
Remove the filter from the filter holder before pouring coffee from the
steel container.
•
The heating element in the base of the coffee machine is hot while it is
switched on. Do not touch this.
•
Turn off the machine after use. For your safety the coffee machine will
turn off automatically after 1 hour.
