11
INSTALLATION
INSTALLATION
■
Drill the screw holes using a
3
⁄
32
" drill bit.
■
Align the holes in the battery mount to the marks. Ensure that you position the battery mount so that the power socket side is
closest to the shade’s power cable.
■
Attach the battery mount using the screws provided.
CAUTION:
Only use the screws provided with the battery mount, designed so that the screws will install flush with the mount.
Protrusion of the screws could result in either the battery wand not attaching properly causing a failure to connect, or the
wand falling out of the mount. Do not over-tighten.
■
Connect the power cable from the shade to the power socket on the rechargeable battery mount. Use a 15", 4', 10', or 20'
extension cable, if necessary.
WARNING:
Keep cables and small parts out of the reach of children. They can wrap cables around their necks and
STRANGLE.
They can also put small parts in their mouths and
CHOKE.
NOTE:
With longer extension cables, wire retainers (not supplied) are recommended to secure the cable.
Install the Battery Wand into the Battery Mount
NOTE:
The rechargeable battery wand ships fully charged, so it is ready to install out of the package.
■
Match the direction of the arrow on the underside of the battery wand with the arrow on the battery mount.
■
Insert the nose of the battery wand into the cavity of the battery mount.
■
Push the battery wand flush into the mount until the battery snaps into place.
CAUTION:
Failing to insert wand properly may cause it to fall out of the mount, posing an injury risk and potentially damaging
the wand. Additionally, when mounting on a door, closing the door with excess force may cause battery wand to dislodge from
the mount, also posing an injury risk and possibly damaging the wand.
Proceed to “Testing the Shade” on page 13.
Battery Mount
Extension
Cable
(If Needed)
Power Cable
from Shade
