5
INSTALLATION
INSTALLATION
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly mark each end of the headrail on the
mounting surface.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail end points over the window opening.
■
Mark 2" from each end of the headrail.
➤
If more than two installation brackets came
with your order, space additional bracket(s)
evenly between the two end brackets and
mark their location.
Allow a minimum of
15" between the brackets on the right-side
motor end for the battery wand.
Mount
into wood whenever possible.
■
Center the installation brackets on your marks and mark where to drill
the screw holes.
➤
A minimum flat vertical surface of 1
1
⁄
4
" for installation brackets or
extension brackets is required.
➤
The top of the installation brackets or extension brackets should be at
the desired height. The brackets should be level and aligned.
➤
When using extension brackets, mark two screw holes per bracket.
CAUTION:
The rear of the brackets must be flush against a flat
mounting surface. Do not mount brackets on curved molding.
■
Drill the screw holes using a
3
⁄
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
■
Attach the installation or extension brackets using the screws provided.
IMPORTANT:
The front edges of the brackets must be level and
aligned to each other.
■
If using spacer blocks, attach the spacer block/installation bracket
assembly to a flat vertical mounting surface with a #6 mounting screw
long enough for a secure installation.
➤
A maximum of 1
1
⁄
2
" of spacer blocks per installation bracket is
recommended. Spacer blocks and shims may be stacked.
➤
Use two
1
⁄
2
" spacer blocks per installation bracket to provide
clearance required for rechargeable battery wand.
➤
A maximum of 1
1
⁄
2
" of spacer blocks per installation bracket is recommended. Spacer
blocks and shims may be stacked.
➤
The top of the spacer blocks should be at the desired shade height.
CAUTION:
Use drywall anchors when mounting into drywall.
■
If using extension brackets, attach an installation bracket to the underside of each
extension bracket using the provided screws and speed nuts.
Proceed to "STEP 2: Mount the Battery Wand" on page 6
Minimum of 15" for Battery Wand
Headrail End Marks
Window Opening
2"
Space Evenly
Space Evenly
2"
Battery
Wand
Rechargeable
Battery Wand
Summary of Contents for Cellular Shade Automation III
Page 22: ...21 INSTALLATION CHILD SAFETY...
