Kirsch Cellular Shade Automation III, Installation Instructions Manual

4

INSTALLATION

INSTALLATION

Mount the Installation Brackets — Inside Mount

■

Measure 2" from each jamb for bracket location.

➤

If more than two installation brackets came 
with your order, space additional bracket(s) 
evenly between the two end brackets and 
mark their location. 

Allow a minimum of 

15" between the brackets on the right-side 
motor end for the battery wand.

 Mount into wood whenever possible.

■

Center the brackets on your marks, then mark each of the screw holes.

➤

Mounting depths vary depending on the fabric cell size. See the following 
chart for minimum and fully recessed depth requirements  
(measured from the front of the sill to the back of the installation bracket).

➤

Mark both winged screw holes with shallow mounting depths.

➤

Mark the center screw hole when depth permits. The center hole requires 1

1

⁄

2

".

Mounting Depth Requirements

Cell Size:

Battery Wand 

High Mount Bracket 

(Standard) 

Battery Wand 

Low Mount Bracket 

(Optional) 

Satellite Battery Pack, 

C-Size Battery Wand,  

18V DC Power Supply,  

16 Shade Power 

Supply

3

⁄

8

",  

3

⁄

4

"

1

1

⁄

4

"

3

∕

8

",  

3

∕

4

"

1

1

∕

4

"

3

∕

8

",  

3

∕

4

"

1

1

∕

4

"

Minimum casement 

depth: 

Inside Mount

1"

1"

1"

1"

1

∕

2

"

1

∕

2

"

Minimum casement 

depth: 

End Mount

1

3

∕

4

"

1

3

∕

4

"

1

3

∕

4

"

1

3

∕

4

"

1

1

⁄

4

"

1

1

⁄

4

"

Minimum casement 

depth: 

Flush Mount

2

3

∕

4

"

3

1

∕

2

"

2

5

∕

8

"

3

3

∕

8

"

2

1

⁄

4

"

3

1

∕

8

"

Minimum mounting 

surface height: 

Outside Mount

1

1

⁄

4

"

1

1

⁄

4

"

1

1

⁄

4

"

1

1

⁄

4

"

1

1

⁄

4

"

1

1

⁄

4

"

■

Drill the screw holes using a 

3

⁄

32

" drill bit. 

CAUTION:  

Use drywall anchors when mounting into 

drywall. 

■

Use a level to check that the mounting surface is level. Shim 
the brackets if necessary. 

■

Attach the installation brackets using the screws provided.

IMPORTANT:  

The front edges of the installation brackets 

must be level and aligned. If mounting to a heavily textured 
surface, shim the brackets, if needed.

Proceed to "STEP 2: Mount the Battery Wand" on page 6

2"

Space Evenly

Jamb

Jamb

Space Evenly

2"

Minimum of 15" for Battery Wand

See Depth

Chart

Use Center Hole

When Depth Permits 

See Depth

Chart

Use Center Hole

When Depth Permits