3
INSTALLATION
INSTALLATION
Valance Assembly
Please refer to the section below for your valance type.
If you didn’t order a valance,
proceed to “Mount the Installation Brakets - Inside Mount” on page 5 or
“Mount the Installation Brakets - Outside Mount” on page 6 based on the mounting option ordered.
Dust Cover Valance Assembly
Single-Tiered Closed Corner
■
Cut a fabric insert for the valance and each valance return 1” longer at each end than the valance and valance return width.
■
Center the fabric insert in the valance and wrap the excess on each side around to the back of the valance.
■
At one end, hold the fabric insert in place with a corner clip.
■
At the opposite end, pull the fabric insert tight and secure it in place with another corner clip.
■
Center each valance return fabric insert and wrap the excess on each side around to the
back of the valance return.
■
Attach the valance return to the valance using the already attached corner clip.
■
At the opposite end of the valance return, pull the fabric insert tight and secure it in
place with a valance return clip.
■
Repeat the previous 4 steps for the other valance return.
IMPORTANT:
Vinyl inserts should be cut flush with the ends of the valance and valance
returns. Secure vinyl in place with the corner clip and valance return clips.
P
roceed to “Mount the Installation Brakets - Inside Mount” on page 5 or
“Mount the Installation Brakets - Outside Mount” on page 6 based on the mounting option ordered.
Single-Tiered Open Corner (Fabric Only)
■
Cut a fabric insert long enough to wrap around the corner and over the entire
return plus at least 1” excess at each end.
■
Attach the corner clip and valance returns.
■
Insert the fabric into the valance, wrap it through the corner clip and into the valance
return.
IMPORTANT:
Leave extra fabric at the other end of the fabric insert to be able to
wrap around the other valance return.
■
Wrap excess fabric around the end of the valance return and secure it with a
valance return clip.
■
Repeat steps 3 and 4 for the other valance return.
P
roceed to “Mount the Installation Brakets - Inside Mount” on page 5 or
“Mount the Installation Brakets - Outside Mount” on page 6 based on the mounting option ordered.
Corner
Clip
Valance
Return
Valance
Valance Return
Clip
Fabric
Insert
Corner
Clip
Valance
Return
Valance
Fabric
Insert
Valance Return
Clip
