TOM1
ADV
Headroom 87
TOM1
ADV
SenseTime 50
TOM1 ADV
Trigger Linear
ADVANCED SETTINGS
Includes all the physical settings for pads/triggers.
- Sensitivity:
The higher the value is, the easier it will be to
trigger. But if this value is too high, will cause some crosstalk
problems.
- Headroom:
Set the velocity dynamic range. This value is
the velocity needed to get max volume, so the lower the
value is, the easier to get louder sounds.
TIP:
You can use the faders to adjust the volume
quickly,
but it will not be saved if you power off the sound
module.
The concept of Headroom is essentially
different from
Volume. Headroom decides the velocity to
reach the max
volume, but cannot change the max level of
volume.
- SenseTime:
Sets the interval between two triggering. In-
crease this value by certain amount may avoid being trig-
gered multiple times by vibration in very short time.
- Trigger:
Sets the velocity curve for pads, including Linear,
EXP1&2, LOG1&2 and Spline. On horizontal is the velocity
you strike, and on vertical is the volume after processed by
the trigger curve.
TOM1 ADV
Sensitivity 77
SETUP
ADVANCE [ENTER]
V
o
l-
ume
V
o
l-
ume
V
o
l-
ume
V
o
l-
ume
Linear
Exp
Log
Spline
Strength
Strength
Strength
Strength
Diagram of 4 types of the velocity curve
SETUP
15
TOM1
ADV
Note Send 48
- Xtalk:
Sets the crosstalk for pads. Use max power to strike
a pad repeatedly until the screen shows OK, and then change
to another pad and repeat the procedure. Velocity data on
other pads will be loaded automatically for reference in order
to avoid crosstalk.
- Note Send:
Set the MIDI note for each trigger. When the
midi note is different between this module and other sound
sources, by adjusting this value they can be easily matched.
TOM1
ADV
Xtalk
Auto
