FarmBoy
®
Agricultural Reaper (Baffle Type)
FB-BC-8642 / 8652
FB-BC4-8636
: www.kisankraft.com
: info@kisankraft.com
: +91.80.22178200
Page 14 of 36
Installing Cutting Blade:
1.
Put the angled bar (1) into the side holes
of the gear case (2) and the plate (3) so
as to fasten the axle.
2.
Mount the blade (4) and the washer (5)
onto the axle.
3.
Mount the washer (6) and the nut (7).
Fasten tightly anti-clockwise.
Installing Cutting Head:
1.
Put the angled bar (1) into the side
holes of the gear case (2) and the plate
(3) so as to fasten the axle.
2.
Mount the trimmer head (8) on the axle.
Fasten tightly anti-clockwise.
Note
Before using the trimmer head, mount the
trimmer knife (E) to protection shield (F) with 3
screws. When the machines is running, tap the
trimmer head on the ground, and trimmer line
will come out automatically. The trimmer knife
will cut and keep the trimmer line in the correct
length.
Connecting Cutting Attachment:
Insert the trimmer cutting attachment (b) into to
the main drive shaft (c) and tighten the knob (a)
on the split connector securely.
IMPORTANT
Align the cutting attachment into split connector
by locking it.
When difficult to engage, twist the shaft housing
slightly.
FarmBoy
®
Agricultural Reaper (Baffle Type)
FB-BC-8642 / 8652
FB-BC4-8636
: www.kisankraft.com
: info@kisankraft.com
: +91.80.22178200
Page 23 of 36
Refilling Trimming Line:
1.
For replacement line, use a diameter
of 2.4mm (.095in). The spool is
capable for a line up to 6m (20ft) on
the 10cm (4”) head. Avoid using a
larger line as it may cut down the
trimming performance.
2.
Pinch the slotted area on the both
sides of the spool housing to unhook
the bottom cap.
3.
Take out the spool and pull off the old
line. Put one end of new line through
the spool holes and pull it until the
length is equal between each part of
the line.
4.
Wind up the line in the correct
direction as indicated on the spool.
5.
Hook each end of the line in the slot
on the edge of the spool, and then
put the ends through the eyelets on
the housing. Make sure that the
spring and the washers are in place.
6.
While holding the spool against the
housing, pull the line ends to release
them from the slot.
7.
Line up the slot on the bottom cap
with the hook on the housing, press
the cap against the housing until it
clicks.
Air Filter:
The air filter, if clogged, will reduce the
engine performance. Monthly check and
clean the filter element in warm, soapy
water as required. Dry completely before
installing. If the element is broken or
shrunk, replace with a new one.
Note: In the adjacent fig:
(1) Air Filter
Fuel Filter:
When the engine runs short of fuel supply, check
the fuel cap and the fuel filter for blockage.
Note: In the adjacent fig:
(1) Fuel Filter
