KisanKraft
®
Agricultural Portable Sprayer (Power)
KK-P767/ P768/ P769/ P780, KK-TPS-60T
Agricultural Knapsack Sprayer (Power)
KK-707/ 708/X/AL, KK-KPS-162 / 802
This warranty is null & void, if you fail to register the warranty with KisanKraft
by
sending the KisanKraft Copy with dealer’s stamp.
: www.kisankraft.com
: info@kisankraft.com
: +91.80. 6835 7800
OPERATING INSTRUCTIONS
Pre-Operation Preparation:
Oiling
1.
Make sure to use 2T exclusive oil.
2.
Make sure that the engine is
stopped and cooled.
3.
Neither overfill nor spill the fuel on
the engine
Dilution of chemicals/Charging the chemical tank
(Applicable for
KK-707/ 708 / KK-708-(AL1) /KK-KPS-802/162
)
Caution
: Agricultural chemicals are extremely dangerous, and must be handled with utmost care.
Read the manual for the specific chemical carefully before use.
Dissolve water dispersible powder in a separate container before filling, be sure not to get foreign
material into chemicals.
Always fill the chemical tank through the strainer so that contaminants are not mixed into the
chemicals.
Open the air bleed nozzle, and bleed until the chemical is draining out, and then close the nozzle
securely .Before spraying the agrochemical, be sure to put on suitable protective clothing to
protect yourself against contact with and breathing it. Observe the following cautions for safe
operation:
a)
Be sure to close the chemical tank cover securely.
KisanKraft
®
2 - STROKE PETROL ENGINE
: www.kisankraft.com
: info@kisankraft.com
: +91.80. 6835 7800
Page 39 of 48
INSPECTION AND SERVICE BEFORE EACH OPERATION
Cleaning of air cleaner
Wash the element with white kerosene and
then immerse it in engine oil.
Squeeze it tightly with single hand.
Use of fire is strictly prohibited
Cleaning and service at respective sections
•
Clean thoroughly around the muffler.
•
Clean the cooling fins and the cooling air inlet.
•
Inspect and retighten bolts and nuts.
•
Inspect the fuel leakage.
INSPECTION AND SERVICE AT EVERY 50-HOUR
Cleaning and adjustment of ignition plug
After removing carbon accumulated on the
electrodes and the insulator, adjust the clearance
between the electrodes at 0.6 ~ 0.7 mm
When mounting the plug cap, push it in securely
Cleaning of fuel filter
Using a piece of wire, or the likes, pull out the fuel filter and wash with clean white
kerosene. When it is fouled heavily, replace the filter and also wash the tank inside.
Use of fire is strictly prohibited
Carbon removal
Remove carbon from the muffler in-/outlet, cylinder and piston.
This work requires engine servicing skill and some tools. Consult the dealer or nearest
service center.
CAUTIONS DURING INSPECTION
•
Disconnect the ignition plug wires before inspection or adjustment to prevent
unexpected start of engine.
•
Do not touch the engine immediately after operation to prevent burn.
•
Use of fire is strictly prohibited when handling the fuel (gasoline).
•
Make sure to clean spilled fuel sufficiently before using the engine.
•
Do not wash the engine with water.
•
Do not change the setting revolution speed carelessly. (Consult your dealer when
changing the revolution speed.)
