KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 13 of 80
Installation and adjustment of cables
Adjustment of clutch cable (Look at picture 1)
1.
Unlock nuts on the screw rod.
2.
Instantaneously rotate the screw rod to show the shortest part of the handle bar.
3.
Connect the clutch cable head into clutch plug behind the gear box assy, thread the
cable into axis pin M6×20, and fix with jump ring.
4.
Properly pull down the clutch cable and fix the clutch cable head to handle bar
bottom.
5.
Rotate out the screw rod and clip it repeatedly, unlock the clutch handlebar until
spring force of clutch can reset the bar, finally fasten the nuts.
Picture 1
Adjustments
1.1
Adjustment of handle bar height
.
•
Loosen the regulating handle, adjust the
handle frame to suitable position, screw
into the regulating handle, and tighten the
wing nut.
•
Loosen the locked handlebar and
standpipe, standpipe and handle frame
can be rotated in 330 °, which has 18
positions. Then tighten the locked handle,
operate the Intercultivator through
adapting to different position.
1.2
Adjustment of Intercultural/Weeding Operations depth
•
Adjust resistance rod downwards, Intercultural/Weeding Operations depth will
increase. Adjust resistance rod upwards, Intercultural/Weeding Operations depth
will decrease.
1.3
Usage and adjustment of clutch.
•
Control power output of engine by clutch.
•
When clutch handle is loosen, clutch is opened, the engine stops inputting power
to Intercultivator , Intercultivator blades stop rotating (Look at picture 5)
•
When we clench the handle lock, clutch is connected. In this condition, power is
transmitted to Intercultivator , blades begin to work. (Look at picture 6)
Throttle cable
Throttle switch
Lock nut
Shut down switch
Clutch handle
bar
Clutch cable
Screw rod
