KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 17 of 80
Assemb
l
y drawing of safety protection guard installation.
1.
Bracket of collision bumper(left)
2.
Bracket of collistion
bumper(front)
3.
Bolt m8 (bg5781-86)
4.
Bracket of collision
bumper(right)
5.
Nut m8(gb41-86)
6.
Spring washer ¢8(gb93-87)
7.
Washer ¢8(gb95-85)
8.
Stand (diesel)
9.
Bracket(right)
10. Nut m6(gb41-86)
11. Spring washer ¢6(gb93-87)
12. Washer ¢6(gb95-85)
13. Bolt m6×10(gb5781-86)
14. Fender for paddy field (right)
15. Fixty of safety protection guard
16. Safety protection guard(right)
17. Safety protection guard(left)
18. Fender for paddy field(left)
19. Dowel
20. Connecting plate
21. Bolt m8×50(gb5781-86)
22. Connector jointing assembly
23. Deep furrowing resistance stick
24. Bolt m8×25(gb5781-86)
25. Bulling set (trough comp
16mm)
26. Bracket of fender comp
27. Bracket (left)
ATTENTION:
After maintenance the safety protection guard installment must be fixed on
the Inter-cultivator wholly.
Installation and Adjustment for cable: Please See Figure 5 and 6
below.
1.
Unscrew the locknut of the tie rod.
2.
Spin the tie rod clockwise until the exposed handle support is the shortest.
3.
Get the joint of cable into the clutch wire socket of rear part of the gear-box
assembly, and ensure the joint of cable goes into the hole of the socket.
4.
Get the wire into the M8 hole on base of the clutch fork arm, properly press the
fork arm of the clutch, and put the joint of cable into the wire socket.
5.
Unscrew the tie rod, grasp and loosen the clutch handle until the spring force in
the clutch can reset the handle, then screw the locknut.
Figure 5