KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 19 of 80
Adjustment of the throttle cable:
(See Figure 7 )
•
Shift
the
throttle
switch
clockwise
to
minimum
positioning.
•
Get wire of the throttle cable
into the threading base and firm
base on
•
Top of the throttle adjustment
board of the diesel engine.
•
Tighten the wire, screw the
binding bolts on the firm base.
•
Adjust
the
throttle
switch
repeatedly until the throttle
handle
on
the
oil
valve
adjustment board can reach
the maximum and minimum
position.
Checks and Refueling:
1.
Check whether all the connection bolts are tight or not, and fix the connection bolts
according to the moment of force listed in table 3. (Refer to the instruction manual
for diesel engine for the screwing moment of force bolt and nut respectively)
Name of parts
Moment of force
(N.M)
Flange and the diesel engine
20-25
Flange and the gear-box
35-40
Binding bolts of end of driving shaft of gear-box
10-12
Binding bolts of reversing gear shaft of gear-box
26-40
Binding bolts between engine support and traveling
mechanism
35-40
Binding bolts of cover of the traveling mechanism
10.6-15
Binding bolts of trailer of the traveling mechanism
50-60
Connection bolts between traveling mechanism and gear-
box
35-40
Trailer unit
45-60
Set bolts of the diesel engine base
35-40
Set bolts of the handle support base
35-40
2.
Check each handle of the manipulation system (throttle switch, clutch, shifting bar
and reversing bar) to see whether they can move freely or not. If they are out of the
right positions, make them at the right positions.
3.
Pull shift bar of the gear-box to the neutral position.
