KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 28 of 80
When the Inter-cultivator needs a long-term storage, the following measures should be
adopted to avoid rust.
1.
The instruction manual of diesel engine requires sealing the diesel engine up for
keeping purpose.
2.
Clean dust and dirt away from the surface of the machine.
3.
Drain the lubricant from the gear-box and add new lubricant into it.
4.
Paint anti-rust oil on the non-painted area of the non-aluminum surface
5.
The machine should be kept in a well-ventilated, dry and soft place.
6.
Keep well the self-contained tools, conformity certificate of product and
instruction manual
Troubleshooting
Troubleshooting of Reversing Gears and Cables:
When the Inter-
cultivator’s running backwards is not normal, it is necessary to adjust the
reversing gears and Cables, see the instructions below.
1.
Grasp and loosen the reversing handle for 2-3 minutes to confirm the putting into gear.
If it is abnormal, adjust it until it is qualified.
2.
When the Inter-cultivator is running, loosen the reversing handle, the reversing gears
should return to its original position and ensure that there is no abnormal sound made
by gears colliding in the gear-box, otherwise, it may cause damage to the gear.
Troubleshooting of Clutch Cables:
After some time use, the clutch does not perform well any more due to the weariness of
friction piece and fork of clutch. As for how to adjust cable of the clutch, refer to instructions
below.
1.
Grasp and loosen the clutch handle for 2-3 times to confirm the clutch status. If
abnormal, readjust it.
2.
If repeated adjustment cannot solve the problem, excess abrasion of fork or
friction piece of the clutch can be confirmed. The machine should be sent to
special service center for replacing with a new fork of friction piece of the clutch.
3.
Dismounting the clutch by unspecialized person, which may cause damage to the
clutch and the machine is forbidden.
Troubleshooting of Accelerator Cables:
When spinning the throttle switch, check if the acceleration or deceleration performance of
the diesel engine is good or not, adjust the throttle switch if necessary. Refer to instructions
for measures.
1.
Repeatedly spin the throttle switch for 2-3 times and confirm whether the
acceleration or deceleration performance of the diesel engine is ok.
2.
Joint of the cable must be firmly connected to the throttle cable.
Use & Troubleshooting of Handle Bar Frame:
According to your height, farming and other special requirements, the handle bar connection
can be adjusted up and down, left and right appropriately as following: (see figure below)