KisanKraft
®
Agricultural Inter-Cultivator
KK-IC-100P / 105P /200P / 205P / 207P / 215P
: +91.80. 6835 7800
Page 23 of 112
NOTE:
After adjusting the tension make sure
that the outside face of the drive pulley is flush
with the outside face of the driven pulley by
using a straight gauge.
(1) ENGINE MOUNTING BOLTS
(2) ENGINE
STAY
TIGHTENING
BOLT
Loosen the attaching bolts of the belt stopper.
Adjust the clearance between the belt stopper
and the belt as illustrated with the clutch lever
squeezed.
(1) BELT STOPPERS
Transportation and Storage
WARNING
When transporting the Inter-cultivator, turn the fuel valve OFF and keep the
Inter-cultivator on a level surface to prevent fuel spillage. Fuel vapor or
spilled fuel may be ignited.
Before storing the unit for an extended period:
1.
Be sure the storage area is free of excessive humidity and dust.
2.
Drain the fuel
Petrol
is
highly
flammable
and
explosive under certain conditions. Do
not smoke or allow flames or sparks in
the storage area.
•
With the fuel valve turned OFF,
remove and empty the fuel
strainer cap.
•
Turn the fuel valve ON and
drain the petrol in the fuel tank
into a suitable container.
•
Replace the fuel strainer cap
and tighten securely.
•
Drain
the
carburetor
by
loosening the drain knob Drain
the petrol into a suitable
container.
1.
O-Ring
2.
Fuel Strainer Cup
3.
Drain Knob
3.
Pull the starter grip until resistance is felt. Continue pulling until the
notch on the starter puller aligns with the hole on the recoil starter
At this point, the intake and exhaust valves are closed and this will
help to protect the engine from internal corrosion
