KisanKraft
®
Agricultural Inter-Cultivator
KK-IC-100P / 105P /200P / 205P / 207P / 215P
: +91.80. 6835 7800
Page 35 of 112
Troubleshooting
Problem
Probable cause
Solution
When the engine
does not start:
Insufficient fuel
Fill the fuel
Fuel valve is not in the ON
position
Bring the fuel valve to ON position
Engine switch is not in ON
position
Bring the engine switch to ON position
Petrol is not reaching the
carburetor
Loosen the drain knob with the fuel valve ON. Fuel
should flow freely. Retighten drain knob
(1) FUEL VALVE
(2) ON
(3) DRAIN KNOB
There is no spark at the
spark plug
a.
Remove the spark plug cap. Clean any dirt
from around the spark plug base, and then
remove the spark plug.
b.
Install the spark plug in the plug cap.
c.
Turn the engine switch on.
d.
Grounding the side electrode to any engine
ground, pull the recoil starter to see if sparks
jump across the gap.
e.
If there is not spark, replace the plug.
2. Clutch has problem
Problem
Probable cause
Solution
Can’t clutch
Clutch rod broken
Change or repair the
clutch rod
Clutch cable broken
Change the clutch cable
Fork or gasket worn out
Change the gasket
Fork pin bent or broken
Change
Friction disk can’t work
Change the friction disk
Spring disk can’t work
Change the spring disk
Friction disk can’t contact with bearing end side
use adjusting gasket
Clutch broken
Change the clutch
Skid
Spring worn out and can’t work
Change the spring
Fork axle can’t turn well
Clean it
Clutch cable is not fitting well
Adjust the cable properly
