KisanKraft
®
Agricultural Inter-Cultivator
KK-IC-210P
This warranty is null & void, if you fail to register the warranty with
KisanKraft by sending the KisanKraft Copy with dealer’s stamp. KisanKraft
Limited
: +91.80. 6835 7800
Page 26 of 64
Lubricate the linkage every 10 hours of use and before long-time storage. Use
10W oil. No parts inside the gearbox are to be lubricated. All bearings and
bushings are permanently lubricated and require no maintenance.
Lubricating these parts will only result in the grease getting on to the friction
wheel and disc drive plate, which could damage the rubber clad friction wheel.
For long time storage the above-mentioned parts should be lightly wiped with
an oily rag to prevent rust.
AIR CLEANER SERVICE
A dirty air filter will restrict air flow to the carburetor, reducing engine perfor-
mance. If you operate the engine in very dusty areas, clean the air filter more
often than specified in the
MAINTENANCE SCHEDULE
.
Operating the engine without an air filter, or with a damaged air filter,
will allow dirt to enter the engine, causing rapid engine wear
.
INSPECTION
1.
Remove the air cleaner cover. Be careful to prevent dirt and debris
from falling into the air cleaner base.
2.
Remove the air cleaner from the air cleaner base.
3.
Inspect the air cleaner elements. Replace any damaged elements.
Clean or replace dirty elements
(1) Paper element
(2)
Foam element
NOTICE
