BATTERY FAILURE OVERRIDE
The KitLock has been designed so an external PP3 battery can be placed against the contact points surrounding the Blue and Red LED’s so the lock can be
opened to replace the batteries should they fail.
The procedure is as follows:
Place the contact points of the PP3 battery against the contact points surrounding the Blue and Red LED’s.
The po PP3 terminal against the Red LED contact point and the negative – PP3 terminal against the Blue LED.
Enter the Master Code.
The motor will withdraw the locking pin allowing the lock to be opened.
Fit new batteries by removing the upper fixing bolt and swinging the lock down over the edge of the door. Refit the lock.
Programming
To program – the lock must be in the open position with the # button visible. Every program command must commence by pressing the # button, followed
by either the Master Code, Sub‐Master Code or User Code.
MASTER CODE COMMANDS
CHANGE THE MASTER CODE
#Master Code
•
01
•
New Master Code
•
New Master Code
••
Example: #11335577
•
01
•
12345678
•
12345678
••
Result: Master Code has been changed to 12345678.
