Lego Drone Kit Instructions
You will need to solder each of the 4 motors (c)
and each of the 4 LEDs (d) to the receiver
board (b). Motor location on the board matters
because 1 set of motors spin in the clockwise
(CW) direction and 1 set of motors spin in the
counterclockwise (CCW) direction.
Get Ready to Solder!
Counterclockwise
(CCW) Motor
Clockwise
(CW) Motor
Use a helping hand to hold the receiver board
while you solder. Start with the wire on the
board facing away from you and the solder
joints facing ”up”. You can tell the solder joints
for the motors as they read “M1” “M2” “M3”
“M4” and for the LEDs as they read “LED3”
“LED4” “LED5” “LED6”
Helping Hand
