Mini Paper Drone Kit Instructions
You will need to solder each of the 4 motors (c)
to the receiver board (b). Motor location on the
board matters because 1 set of motors spin in the
clockwise (CW) direction and 1 set of motors
spin in the counterclockwise (CCW) direction.
You can tell the difference based on wire colors.
Get Ready to Solder!
Of note, you may
receive a set of
Red/White wires.
Charging Battery
Charge battery by plugging JST
connector from Lipo battery to JST/USB
cable (of note, your USB charger may
not have a “cable” just a USB to JST as
pictured with the computer below). We
recommend charging the battery prior to
your first flight. You can charge the
battery while it’s attached to the drone
as well.
