5
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the control to the Off position as
shown and then disconnect the refrigerator from the electrical
source.
When you are finished, reconnect the refrigerator to the electrical
source and reset the control to the desired setting. See “Using
the Control.”
INSTALLATION
INSTRUCTIONS
Unpacking
Removing packaging materials
■
Using a T–16 torque wrench, remove skids from the bottom
of the refrigerator and properly discard the attachment bolts.
■
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see the “Refrigerator Safety” section.
■
Dispose of all packaging materials properly.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your refrigerator before using it. See the cleaning instructions
in the “Refrigerator Care” section.
Install the Leveling Legs (optional)
IMPORTANT:
■
Always lay the refrigerator with the hinge facing upward
during the leveling leg installation. If you lay the refrigerator
on its back, you can damage the refrigerator.
■
Do not place refrigerator on its top. It may damage the
compressor.
■
Allow the refrigerator to sit upright for 4 hours before plugging
into an electrical outlet.
1. Using two or more people, lay the refrigerator on its side.
2. Screw two leveling legs into the bottom of the refrigerator at
the front.
3. Screw two leveling legs into the bottom of the refrigerator at
the rear.
4. Using two or more people, stand the refrigerator upright.
5. Allow the refrigerator to sit upright for 4 hours.
IMPORTANT: To prevent floor damage, keep the cardboard
shipping piece or plywood under the refrigerator until it is
installed in the operating position.
6. Move the refrigerator to its final location. Be sure to move the
refrigerator straight back and evenly into the opening.
7. Lower the front legs just enough to lift the cabinet up off of
the floor.
8. Adjust the legs to level the refrigerator:
■
Turn the leveling leg to the right (clockwise) to lower that
side of the refrigerator.
■
Turn the leveling leg to the left (counterclockwise) to raise
that side of the refrigerator.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving it.
Do not wiggle or “walk” the refrigerator when trying to move
it, as floor damage could occur.
Summary of Contents for 2311008
Page 13: ...13 Notes ...
