3
Tools needed:
■
Utility knife
■
Needle-nose pliers
■
Tape measure
■
Flat-bladed screwdriver
■
#2 Phillips screwdriver
■
Side cutting pliers
■
Pencil
■
Sandpaper
■
Level
■
Adjustable wrench that
opens to 1
¹⁄₈
" (29 mm)
■
7 mm socket wrench
■
5 mm socket wrench
■
5 mm open end or box end
wrench
■
Electric or hand drill
■
1
¹⁄₂
" hole saw
■
Valve (sized to fit hot water
supply line) with
³⁄₈
" male
compression fitting
■
Protective floor covering
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Parts supplied:
Located in drawer:
■
2 flexible trim pieces (for sides)
■
Edge protection
■
Hose clamp, screw type
■
Washer
■
Drain hose support
■
Drain hose connector
■
Hose clamp, wire type
■
11,
⁵⁄₈
”
long, #8 Phillips head wood screws
■
Moisture protection tape
■
3,
1
”
hex head wood screws
■
3,
⁹⁄₁₆
”
washers
INSTALLATION REQUIREMENTS
Location Requirements
IMPORTANT:
Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
■
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
■
Install the dishwasher as specified in these instructions.
■
Have everything you need to properly install dishwasher.
■
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
■
This dishwasher is manufactured for indoor use only.
■
Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 lbs. (47 kg), and is in an area suitable for its
size and use.
Product dimensions
23
⁷⁄₁₆
"
(59.5 cm)
22
⁷⁄₁₆
"
*
(57 cm)
16
³⁄₃₂
"
(40.9 cm)
side
attaching
tabs
20
¹⁵⁄₃₂
"
(52 cm)
drawer open
*
If custom wood panels are to be used, the product depth is specified with an
¹¹⁄₁₆
" (18 mm) door panel thickness.
NOTE:
Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
■
Drain hose 88
⁹⁄₁₆
”
(2250 mm): Extension kit available - part
■
no. 8194400
■
Inlet hose 68
⁷⁄₈
”
(1750 mm)
■
Power cord 44
”
(1125 mm)
