16
| USING THE STAND MIXER
USING THE STAND MIXER
3
Insert attachment shaft housing into
attachment hub, making certain that
attachment power shaft fits into
square attachment hub socket. It may
be necessary to rotate attachment
back and forth. When attachment
is in proper position, the pin on the
attachment will fit into the notch
on the hub rim.
4
Tighten attachment knob by turning
clockwise until attachment is
completely secured to Stand Mixer.
5
Plug into proper electrical outlet.
6
To remove:
Turn speed control
to “0”. Unplug Stand Mixer.
7
Loosen attachment knob by
turning it counterclockwise. Rotate
attachment slightly back and forth
while pulling it out.
8
Replace attachment hub cover.
Tighten attachment knob by turning
it clockwise.
NOTE:
See the Use and Care Guide of each specific attachment for recommended
speed settings and operating times.
W11256121A.indd 16
14/06/2018 15:29:27