BURNERS
Cleaning Method:
◼
Clean the exterior of the burner with a wire brush.
◼
Clear any clogged burner ports with a straightened paper
clip.
◼
Do not use a toothpick as it may break off and clog the
port.
◼
Check and clean burner/venturi tubes.
1.
Remove grill grates and flame tamers.
2.
Remove the 2 screws and cotter clip that hold the burner
in place. Set the screw and clip aside.
3.
Use a flashlight to inspect into the burner through the
burner inlet to ensure there is no blockage. If any
obstruction is seen, use a metal coat hanger that has been
straightened to clear them.
4.
After inspecting the inside of burner for blockage,
reassemble burner by sliding the middle tube of the gas
burner over the gas orifice.
5.
Reattach using the cotter clip and screws previously
removed. Repeat the procedure for each main burner.
A.
Burner/orifice connection
SEARING BURNER AND GRATE
Cleaning Method:
◼
Clean with a brass bristle brush.
◼
Wash grate using mild detergent, warm water and
degreaser.
◼
Rinse with clean water and dry with soft, lint-free cloth.
◼
Stainless steel cleaner.
ROTISSIERE BURNER
Cleaning Method:
1.
Light the rotisserie burner. See the “Using Your Rotisserie
Burner” section.
2.
Close the grill hood.
3.
Leave the burner on high for approximately 30 minutes.
4.
Turn knob to OFF and let cool completely.
5.
Brush off ash particles from the rotisserie burner.
ROTISSIERE KIT
Cleaning Method:
◼
The meat forks and spit rod should be washed in warm
soapy water after each use. Do not immerse the motor,
cord or plug in water.
◼
Store the rotisserie kit indoors when not in use; out of the
reach of children.
SIDE BURNER
Cleaning Method:
◼
Clean the exterior of the side burner with a wire brush.
GREASE TRAY
IMPORTANT:
The grease tray should only be removed when
grill is completely cool.
The grease tray collects grea se and food particles that fall
through the grill. Clean often to avoid grease buildup.
Cleaning Method:
◼
Remove the grease tray.
◼
Wipe excess grease with mild detergent and warm water
using paper towels.
◼
Rinse and dry thoroughly.
◼
Replace grease box.
KNOBS AND FLANGE AREA AROUND KNOBS
IMPORTANT:
To avoid damage to knobs or flange area
around knobs, do not use steel wool, abrasive cleaners, or
oven cleaner.
Do not soak knobs.
Cleaning Method:
◼
Mild detergent, a soft cloth and warm water.
◼
Rinse and dry.
CONTROL PANEL GRAPHICS
IMPORTANT:
To avoid damage to control panel graphics, do
not use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
◼
Clean around the burner labels gently; scrubbing may
remove printing.
◼
Mild detergent, soft cloth and warm water.
◼
Rinse and dry.
47
A
Summary of Contents for 720-0826E
