22
Setting Oven Controls
Operating Oven Light
The interior oven light will automatically turn ON when the
oven door is opened.
Press
Oven Light
to turn the interior oven light ON and
OFF whenever the oven door is closed. Note that the oven
light will not work during a Self Clean cycle.
The interior oven light is located at the upper left rear wall
of the oven interior and is covered with a glass shield held
by a wire holder. The glass shield protects the bulb from
high temperatures and should always be in place
whenever the oven is in use.
To replace the interior oven light, see
Replacing oven
light
in the Care & Cleaning section.
Restoring Default Settings
Important note:
Restoring your default settings will reset all recipes and
other adjustments to factory settings. These include 12 or
24 hour display, continuous bake or 12-Hour Energy
Savings mode, silent or audible control mode, Fahrenheit
or Celsius temperature display and any oven temperature
adjustment settings that have been made.
1. Press and hold the
7
keypad until the first single tone
sounds (6 seconds).
2. After the first tone press
START
once.
Electrical outlet and circuit protection
(on some models)
For protection against surcharge, a 15 amp, 110 volt circuit
breaker reset is provided near the electric outlet located
on top of backguard panel. If needed, press circuit breaker
switch to reset.
Adjusting Oven Temperature
Your appliance has been factory calibrated and tested to
ensure an accurate baking temperature. For the first few
uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is
cooking too hot or too cool for your recipe times, you may
adjust the control so the oven cooks hotter or cooler than
the oven temperature displayed.
The oven temperature may be increased as much as
+35°F (+19°C) or decreased -35°F (-19°C) from the
factory calibrated settings.
Example To increase (+) or decrease (-) the
oven temperature by 20°F:
1. Press and hold
Bake
keypad until the control provides
the 2nd audible tone (about 6 seconds).
2. Enter
2 0
using numeric keypad.
3. Press
Self Clean
keypad to toggle between plus (+) if
increasing temperature or minus (-) if decreasing the
temperature. These symbols will show in the display.
4. Press
START
to accept change.
Important notes:
Oven temperature adjustments made will not change
the Broil or Self Clean function temperatures.
If the temperature shows an adjustment of -20°F, and a
+20°F adjustment is needed, you can toggle between
the minus (-) or plus (+) in the display when pressing
Self Clean keypad (See step 3).
DO NOT USE oven thermometers such as those
found in grocery stores to check the temperature
settings inside your oven
. These oven thermometers
may vary as much as 20 to 40°F degrees from actual
temperatures.
The oven temperature adjustment may be made if your
oven control has been set to display °C (Celsius)
temperatures. Maximum and minimum settings for
Celsius are plus (+) or minus (-) 19°C respectively.
Summary of Contents for ARCHITECT II KERS206X
Page 1: ...Models Modèles KERS206X KERS208X W10328277A 316902700 ...
Page 36: ......
