10
REFRIGERATOR USE
Using the Controls
The control panel is located at the top front of the refrigerator
compartment.
IMPORTANT:
■
After you plug in the refrigerator, it automatically begins to
cool.
■
The indicator LEDs on the control panel light up for
approximately 1 second, and following the initialization
process the temperature set point is displayed.
■
The recommended temperature setting should be correct for
normal household refrigerator use. The controls are set
correctly when milk or juice is as cold as you like and when ice
cream is firm.
■
Wait at least 24 hours for your refrigerator to cool completely
before adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
■
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
Temperature Controls
For your convenience, the temperature control is preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
Recommended Setting “Middle”
Temperature Selection
If you want to adjust the temperature in both the freezer and
refrigerator compartments, use the temperature settings listed in
the chart below as a guide.
Press the temperature control button to toggle through the
temperature selections from High (least cold) to Middle (colder) to
Low (coldest).
NOTE: Do not adjust the control more than one setting at a time.
Wait 24 hours between adjustments for the temperature to
stabilize.
Fast Cool
The Fast Cool feature increases the cooling speed when a large
amount of food is placed in the refrigerator, or fresh food to be
frozen is placed in the freezer.
■
Press and hold the button for 3 seconds until the Fast Cool
(yellow LED) illuminates.
■
The Fast Cool feature will remain on for 6 hours unless it is
manually turned off.
■
Manually turn off Fast Cool by pressing and holding the
control button for 3 seconds until the (yellow LED) is off.
Failure Alarms
After the refrigerator is plugged in, during the first 10 minutes of its
performance, possible temperature sensor failure will be
displayed as shown in the following chart. Although the
refrigerator will continue to cool, it is necessary to call Service and
provide the alarm code. See either the front cover or the Warranty
for contact information.
Failure Alarm Codes
A. Temperature control button
DISPLAY
TEMPERATURE
High
Mid-High (Eco Green)
A
Middle (Recommended)
Mid-Low
Low
A. Fast Cool LED
B. Internal light switch
Evaporator
Refrigerator
Refrigerator and Evaporator
Heater Connections
DISPLAY
TEMPERATURE
A
B
