7
English
assEmblIng thE IcE crEam makEr
assEmblIng thE IcE crEam makEr
attaching the dr_ive assembly for_ tilt-head mixer_s
5
Make sure the motor head is down
completely.
3
Slide drive assembly onto the motor
head until it will not slide any further.
When properly assembled, the outer
curved edges of the drive assembly
should center on the motor head. If
they are not centered, slide the drive
assembly either back or forward until it
is centered on the motor head. Make
sure the drive assembly is securely in
place by pressing upward.
1
Be sure the Stand Mixer is still OFF and
unplugged. Keep the motor head tilted
back and put the dasher and freeze bowl
into place.
4
Lower the motor head to engage the
drive assembly with the dasher. If the
drive assembly doesn’t engage the
dasher, slide the drive assembly either
back or forward until it does engage
the dasher properly.
No Spring
Step
Spring
No Step
2
Determine your mixer model by
checking for a spring on the beater shaft,
and then position the drive assembly as
illustrated for proper placement.
6
Place locking lever in the LOCK
position. Before mixing, test the lock by
attempting to raise the motor head.