4-4
REMOVING THE WATER RECIRCULATION PUMP
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1.
Unplug ice maker or disconnect power.
2.
Turn off the water supply to the ice maker.
3.
Move the ice maker to gain access to the
rear of the unit.
4.
Disconnect the drain outlet hose from the
ice maker.
5.
Disconnect the water inlet line from the ice
maker.
6.
Open the ice maker door.
7.
Remove the ice from the storage bin.
8.
Remove the top cover (see page 4-22 for
the procedure).
9.
Remove the ice scoop from its holder.
10. Remove the hex screws from the holder
and remove the holder from the unit.
Holder
Ice Scoop
13. Push out on the left and right locking tabs
and pull the water reservoir out of the unit.
11. Squeeze the locking tabs on the tube clip
and remove the tube from the water reser-
voir.
12. Pull the other end of the tube off the water
recirculation pump.
Push Locking Tab Out (On Each Side)
Reservoir
90
°
Tube Clip
Summary of Contents for KAR-13
