KitchenAid KCDP 9010/I, Instructions For Use Manual

• The hood has two identical brackets for

attaching the chimney. 
Attach the first bracket (

G

– the side with fixing

holes facing upwards – 

see Fig. 6

) to the wall

next to the ceiling, using the support bracket as
a template (the small slots cut in the bracket
should coincide with the centre lines previously
traced on the wall), mark 2 holes with a pencil,
drill the holes and attach the bracket with 2
screws and plugs. 
Attach the second bracket (

M

– the side with

holes for attaching facing upwards – 

see Fig. 6

)

above the lower bracket at a distance of
200mm, attach the bracket with 2 screws and
plugs. 2 rubber strips should be attached to the
sides of this second bracket (one strip on each
side – cut the rubber strip provided into two
identical halves). 

•

Recirculation mode Only:

fit the deflector to

the chimney support bracket. 

Fig. 6

•

Chimney size:

the chimney is supplied in a

standard size and can then be cut to measure as
shown in 

Fig. 7

. 

Installation

9

Deflector

chimney
support bracket

chimney
support
bracket

bottom
fastener locations

lower
support bracket

lower
fitting device
bracket

centre line