KitchenAid KDDD 6010, Assembly Instructions Manual

PLEASE NOTE: Your model of 

may differ from the model shown in the installation diagrams.

Installation is similar for all models either Single or Double. 

Information referring to Single models only is in

italic.

Installation diagrams have been simplified to enable clearer instruction. FOR INTEGRATED

PRODUCTS FOLLOW THE INTEGRATED PANEL PREPARATION INSTRUCTIONS P/N 526610,
BEFORE MOVING THE PRODUCT INTO THE CAVITY.

READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY.

R

Installation instructions

14

WARNING!

Be careful of sharp edges.

Important!
DO NOT push middle of drawers.

MOUNTING TAB OPTIONS

The mounting tabs are in pairs, one on each side of the product.
They are used to secure the product to the cavity sides. Installation
requires two sets of tab pairs be used, either 

A

and 

B

tab pairs or 

B

and 

C

tab pairs. All tabs would be optimum.

1

If the top installation tabs 

C

are to be used, fit to the chassis by

inserting into the top slots as shown. Ensure the tabs are fully
locked in place.

2

Check cavity for any obstructions that may interfere with sliding
the product back. Loosen the feet DOUBLE MODELS ONLY.

3

Push product into cavity to suit adjacent cabinetry. Do not push
middle of drawer(s). Ensure inlet, drain hose(s) and power supply
cord are not restricted or damaged by carefully pulling all excess
length through the services hole, while the product is being
pushed back into the cavity.

FOR SINGLE MODELS, check that the base of the product is not
bowed. Do not rest single models on your knee when moving them
into the cavity.

Step 1: moving the product into the cavity

1

3

2

5019_102_00273_INSTAL_GB  30-05-2007  13:25  Pagina 14