KitchenAid KDDD 6010, Assembly Instructions Manual

• Ensure product is level, securely fastened to the cabinetry and opens and closes freely. The 

must be free to close with no resistance from the cabinetry.

• Ensure inlet hose to valve connection is tightened a further half turn after seal contact.
• Ensure any knockouts or plugs in drain connection have been drilled out and drain connection has been

made.

• Turn ON the power and water supply. The 

should beep and light up.

• Open the drawer(s) and check operation of Wash Programme Control Panel and check the sprayarm(s)

are in place and free to rotate.

• On the Wash Programme Control Panel select Rinse and close the drawer(s). Start the programme by

pressing the Start/Pause button.

• After the Rinse programme has finished, ensure machine has run and drained correctly.
• Check water supply and drainage connection for leakage.
• Repeat for each Drawer.

- LEAVE ALL LITERATURE WITH CUSTOMER.

TROUBLE SHOOTING

• Excessive water remaining above the filter plate, after the rinse cycle; check for kinked drain hoses or

blocked waste connection.

• No water supply; check water is connected, ON and there is water pressure.

•

does not light up when the tub is opened; ensure power is connected and is switched ON.

• Water around water supply and drainage connections - check connections, existing plumbing and hoses

for leaks.

• If a fault occurs, consult the Fault Code Section of the User Guide.
• If unable to resolve, contact your Customer Care Centre.

R

R

R

Step 11: Final checklist (double and single models)

21

If you have any questions concerning the installation of this 

, please see your User Guide or

Warranty information for contact details.

R

Step 12: customer support

5019_102_00273_INSTAL_GB  30-05-2007  13:25  Pagina 21