21
NOTE:
Route water supply, drain hose, and power cord out the
rear of the dishwasher. If your product has insulation around the
bottom, route these lines through the slits in that insulation in the
rear of the product.
27.
Move dishwasher close
to cabinet opening
Route the utilities through the holes in the cabinet, and pull
the slack out at the same time as the dishwasher is pushed into
the cabinet.
28.
Route power cord
If using a power cord, make sure to route the end through hole
in cutout before sliding dishwasher into the cabinet opening.
29.
Secure insulation blanket
NOTE:
Make sure insulation blanket is secured at both left and
right rear corners before pushing into cabinet opening to keep the
blanket from bunching up in a tight fitting cabinet. The blanket
can be secured by pulling the insulation down toward the bottom
of the product and ensuring the hooks on the side members grab
onto the slots in the insulation blanket.
6"
(15.2 cm)
30.
Move dishwasher all but 6
"
(15.2 cm)
into cabinet opening
■
Place Top Foam Sound Insulation (on some models)
•
Snug the top foam into the slot on the top collar of the
dishwasher as shown in the figure.
NOTE:
Leave unit about 6" (15.2 cm) out from cabinet in order
to install anchor brackets.
NOTE:
Pull slack out of utilities at the same time the dishwasher
is pushed into the cabinet opening to avoid any kinks.
CUSTOM PANEL INSTALLATION
(CUSTOM PANEL MODELS ONLY)
For custom panel installation, refer to the Custom Panel
Installation Instruction Sheet included in the literature package.
Complete custom panel installation before proceeding to the
“Choose Anchor Attachment Method” section.
CHOOSE ANCHOR ATTACHMENT METHOD
IMPORTANT:
The dishwasher must be secured to the cabinet
as one of the final steps. Prepare the dishwasher for this by
attaching the 2 brackets found in the parts bag to the dishwasher.
– For countertops that are wood, laminate or another similar
surface: use Countertop Attachment and go to Step 32.
– For countertops that are marble, granite, or another hard
surface: use Side Attachment and go to Step 33.
NOTE:
If the gap between the top of the door and the underside
of the counter top is tight (less than 1/4" [6.35 mm]), we suggest
using Side Attachment to keep from scratching the User Interface
or console with the anchor screws.
Water
line
Drain
hose
Cable
Secure
blanket
Insulation
blanket
31.
Pull slack from utilities
