8
4.
Add strain relief.
Style 1: Power supply cord strain relief
■
Assemble a UL listed strain relief in the opening.
■
Feed the power supply cord through the strain relief on
the cord/conduit plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
■
Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
■
Use Phillips screwdriver to remove screws and rotate/
conduit plate 180º.
■
Position cord/conduit plate as shown in the following
illustration.
■
Replace cord/conduit plate and insert screws.
■
Assemble a UL listed conduit connector in the opening.
■
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■
Tighten strain relief screw against the flexible conduit.
5.
Replace back panel and screws on rear of range.
6.
Complete installation following instructions for your type of
electrical connection:
4-wire
(recommended)
3-wire
(if 4-wire is not available)
A. UL listed strain relief - large opening
B. Small opening
A. Large opening
B. Small opening
A. Small opening
B. Large opening
A
B
A
B
A
B
A. Small opening
B. Large opening
A. Removable retaining nut - small opening
B. Conduit connector
C. Large opening
A
B
A
B
C
